Alliance Laundry Systems Automatic Clothes Dryers - Manuel (Page 10)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
511250 8
Before You Start
Tools
For most installations, the basic tools you will need are:
Figure 1
Gas
Dryer is equipped for Natural Gas with a 3/8" NPT gas
supply connection. For more detailed information,
refer to Section on Gas Requirements.
Location
Place the dryer on a solid floor with an adequate air
supply. For more detailed information, refer to Section
on Location Requirements.
Exhaust
Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
Figure 2
NOTE: For more detailed information, refer to
Section on Dryer Exhaust Requirements.
Electrical
ELECTRIC DRYER
Dryer needs a 4 wire 120/240 Volt, 30 Amp, 60 Hertz,
1 Phase electrical supply.
GAS DRYER
Dryer needs a 120 Volt, 15 Amp, 60 Hertz, polarized
3-slot effectively grounded receptacle.
NOTE: For more detailed information, refer to
Section on Electrical Requirements.
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the
manufacturer or its service agent and is to be replaced
by a qualified service person.
D818I
1 Wrench
2 Screwdrivers
3 Level
4 Teflon Tape
5 Duct Tape
1
2
3
5
4
Any disassembly requiring the use of
tools must be performed by a suitably
qualified service person.
W299
WARNING
D314I