Agri-Fab 45-0418 - Manuel (Page 16)

16
reMOVING The BeLT (Figures 32-35)
Remove the key and disconnect the spark plug wire •
from the snow thrower.
Remove the engine pulley cover, the drive cover and
•
the skid plate from the snow thrower.
Disengage the snow thrower clutch.
•
Remove the belt from the top pulley. •
Engage the clutch. •
Remove the belt from the bottom pulley. •
Disengage the clutch. •
Lift up on the brake assembly and slip the belt between •
the brake assembly and bottom pulley to remove the
belt from the snow thrower.
INSTALLING The BeLT
Lift up on the brake assembly and slip the belt between •
the bottom pulley and the brake assembly.
Engage the clutch.
•
Install the belt around the bottom pulley. •
Disengage the clutch. •
Install the belt around the top pulley. •
Make sure the belt runs inside all of the belt keepers. •
Replace the covers. •
Replace the key and reconnect the spark plug wire. •
SKID PLATE
PULLEY COVER
DRIVE COVER
BRAKE ASSEMBLY
FIGUre 32
FIGUre 33
FIGUre 34
FIGUre 35