Nyrius ARIES Prime - Manuel (Page 9)

- 9 -
SETUP
MODE STATUS
POWER
LED
STATUS
LED
OSD DISPLAY
STANDBY Power-save mode Solid RED oFF
WARM-UP During 15-20 second
warm-up
Flashing
BLUE
Flashing
SEARCHING
CHANNELS
System not able to establish
link after 80 seconds (see
Notes A and D)
Flashing
BLUE
Flashing
WIRELESS
MODE
No input from selected
source (See Note B)
Solid BLUE
Flashing
quickly
Video format not
recognized (See Note C)
Solid BLUE
Flashing
slowly
Video format is recognized Solid BLUE
Solid
BLUE
-
Alternates
between
images on
oSD
4 Levels
looping -
Searching
NOTES
A. If the system is unable to establish a connection within 80 seconds, the connection has
been lost or the Transmitter is out of range. Verify the distance between the Transmitter and
Receiver. The maximum video transmission range for 1080p content is up to 30ft. in line of
sight (LoS). The minimum range is 6.5 ft.
B. Please confirm that the computer is powered oN and that HDMI oUT has been selected; check
that HDMI cable is properly connected.
C. If no video is displayed and oSD message states "NoT SUPPoRTED FoRMAT", then the video
frame rate from the computer is NoT supported. See " Supported Resolution" section to
change resolutions.
D. If you have more than one pair of each Transmitter/Receiver, each pair should be at least 6.5
feet away from each other. If both pairs of Transmitter/Receiver are in the same room, the
suggested the distance between the two is a minimum distance of 6.5 feet.
9. If all is operating normally, the PoWER LED and INFo/CHANNEL LED will be SoLID BLUE. Please
refer to the chart below for detailed LED and oSD transmitter/receiver alert descriptions: