Dynalab 3999-0000 - Manuel (Page 2)

[ 2 ]
BEFORE USE
If the equipment is not used in the manner described
in this manual the protection provided by the
equipment may be impaired.
N.B. The Distinction Water Still is classified as
“Permanently Connected Equipment” and should be
connected to the electricity supply by a qualified
electrician in the manner described in the electrical
installation section of this manual.
The Distinction Water Still is designed to operate under the
following conditions:
❖
For indoor use only
❖ Ambient temperature range +5°C to +40°C
❖ Altitude up to 2000m
❖ Relative humidity not exceeding 80%
❖ Mains supply voltage fluctuations not greater than
±10% of nominal
❖ Overvoltage category II IEC664
❖ Pollution degree 2 IEC664
Limitations of use
This product meets the applicable E.C. harmonised
standards for radio frequency interference and may be
expected not to interfere with, or be affected by other
equipment with similar qualifications. We cannot be sure
that other equipment used in its vicinity will meet these
standards and we cannot guarantee that interfer ence will
not occur in practice. Where there is a possibility that injury,
damage or loss might occur if equipment malfunctions due
to radio frequency interference, or for general advice before
use, please contact the Technical Service Department of
Bibby Sterilin Ltd.
Distinction Water Still D4000 & D4000/EURO
The Distinction Water Still complies with the
following European Directives:
89/336/EEC
- E.M.C. DIRECTIVE
Amended by 92/31/EEC and 93/68/EEC
73/23/EEC
- L.V.D. Amended by 93/68/EEC
Figure 1 General Assembly
Thermostat
reset
buttons
Boiler
thermostat
tube
On/Off switch
Clip
Reservoir
level
control
Heater Gaskets
and flange
Distillate
outlet tube
Boiler
Stand
Stopcock
To drain
Constant
level control
Wall mounting
screw holes
Cooling water
inlet
Condenser
thermostat tube
Condenser
outlet
Straps
Condenser
Condenser
thermostat
Boiler
thermostat
Distinction