NaceCare Solutions TTV4555 - Manuel (Page 13)

13
When handling and mixing chemicals.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-driers.
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
After use, ensure the chemical dosing tank is emptied, cleaned and refilled with clean water.
The dosing pipes also need to be cleaned and flushed through with clean water for at least 60 seconds after use.
!
!
!
!
Chemical dosing System
Note: always ensure that the waste-water tank is empty before lifting.
The TTV-4555 scrubber dryer has an optional automatic chemical-dosing system.
Simply fill the 5 litre chemical dosing bottle and the machine will deliver the correct mix ratio as set by the operator,
using the setting on the control panel (see page 15) depending on the floor and cleaning conditions.
To fill the chemical-dosing bottle, first make sure the top waste tank is fully drained then, lift up the waste-water tank
(Fig 23), unscrew the bottle cap then remove the dosing bottle, (Fig 24) and fill with appropriate cleaning chemical.
Refit dosing bottle (Fig 25) and replace bottle cap, and carefully lower waste-water tank.
Note: The top (waste) tank is fitted with a pressure sensor that disables the machine until the top tank is closed.
The machine is now ready to be moved to the cleaning site.
Before performing the cleaning operation, place-out appropriate warning signs and sweep or dust-mop the floor
Fig 23
Fig 24 Fig 25