Napoleon Fireplaces 1400C Cast Iron Stove - Manuel (Page 22)

22
W415-0762 / C / 10.27.11
Drywall dust will penetrate into the blower bearings,
causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with
the blower or its compartment. Any damage result-
ing from this condition is not covered by the war-
ranty policy.
Use of the blower increases the output of heat.
NOTE: If the optional blower (EP62-1) is in-
stalled, the blower guard (W320-0011) must
be installed. This guard is available from your
Napoleon dealer.
Attach the mounting bracket to the blower as-
sembly. Then attach the mounting bracket to the
back of your appliance, push on the variable speed
knob and plug into any grounded electrical outlet.
See “BLOWER INSTALLATION” leafl et for detailed
instructions.
MOUNTING
BRACKET
BLOWER GUARD
VARIABLE
SPEED
SWITCH
BLOWER
ASSEMBLY
Provisions have been made on the appliance to
install an optional ash drawer kit.
The EPAD-KT kit allows for convenient removal
of excess ash. This kit can be purchased through
your authorized dealer / distributor.
IMPROPER DISPOSAL OF ASHES RESULT IN FIRES. DO NOT DISCARD ASHES IN CARDBOARD
BOXES, DUMP IN BACK YARDS, OR STORE IN GARAGES.
IF USING A VACUUM TO CLEAN UP ASHES, BE SURE THE ASHES ARE ENTIRELY COOLED. USING
A VACUUM TO CLEAN UP WARM ASHES COULD CAUSE A FIRE INSIDE THE VACUUM.
NEVER OPERATE YOUR APPLIANCE WITH THE ASH PLUG (IF APPLICABLE) REMOVED.
FAILURE TO ACHIEVE A GOOD SEAL BETWEEN THE ASH OPENING, ASH PLUG OR ASH WELL DOOR
WILL RESULT IN AN OVER FIRE CONDITION THAT COULD CAUSE DAMAGE TO THE APPLIANCE.
!
WARNING
!
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK.
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
VOID THE WARRANTY AND CERTIFICATION.
ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
CORD BENEATH THE APPLIANCE.
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
CONTACT WITH MOVING OR HOT OBJECTS.
51.5
6.0 OPTIONAL KIT INSTALLATIONS
6.1 OPTIONAL BLOWER INSTALLATION
6.2 OPTIONAL ASH DRAWER (1100PL/1400PL ONLY)