Napoleon Fireplaces EFL100 - Manuel (Page 12)

W415-1140 / A / 07.04.13
12
EN
5.0 OPERATING INSTRUCTIONS
Once the appliance has been plugged in to a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, the fl ame will turn on indicating that the power has been restored.
5.1 OPERATING BY REMOTE CONTROL
NOTE: Make certain the batteries are installed correctly, for installation
instructions review "
REMOTE BATTERY INSTALLATION" section.
A. When operating the remote control, it must be directed towards the front
center of the appliance.
B. The power button can be used to power up or down the appliance.
Pressing this button
activates the power to the appliance.
C. To turn off the appliance, press the power button once.
NOTE: This remote control must remain within 8 meters or 26 feet of the
appliance to be effective.
6.0 MAINTENANCE
!
WARNING
PREPARATION FOR MAINTENANCE
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
DO NOT INSTALL REPLACEMENT LAMPS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE HALOGEN LAMPS IN YOUR APPLIANCE CAN BECOME EXTREMELY HOT. ALLOW AT LEAST
10 MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE LAMPS TO AVOID
ACCIDENTAL BURNS.
DO NOT HANDLE THE LAMP WITH BARE FINGERS, OILS FROM YOUR SKIN WILL DAMAGE THE
LAMPS WHEY THEY HEAT UP. USE GLOVES OR A CLEAN DRY CLOTH WHEN HANDLING LAMPS.
6.1 REMOTE BATTERY INSTALLATION
1. To replace the existing battery remove the
battery holder.
2. To remove the battery holder turn remote onto
front side and press the left side leaver towards
the center while pulling the battery holder out
using the slot provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into
the remote by sliding it into position, as shown.
4. Battery holder is secure into the remote control
when a "CLICKING" noise is heard.
REMOTE
(REAR SIDE)
BATTERY HOLDER
BATTERY (CR 2025)