Dee Zee FX21962 - Manuel (Page 11)

10
Using the pictures below as a guide, first drill three 1/8” holes through the mudflap on the running board and the sheet
metal in the wheel well opening of the vehicle. Secure the mudlfap to the sheetmetal of the wheel well opening using
#10 x 5/8" phillips head screws (Q) as shown in Step 11 of this instruction. Tighten until snug using a phillips head
screwdriver. Now drill a 1/8" hole through the bottom of the mudflap and the fx running board as shown below. Secure
the mudlfap to the bottom of the fx running board using #10 x 5/8" phillips head screws (Q) as shown in Step 11 of this
instruction.
En utilisant les images ci-dessous comme guide, premiers trous du foret trois 1/8"par le mudflap sur le conseil courant et
métal de feuille dans l'ouverture de soute de train du véhicule. Fixez le mudlfap au métal en feuilles de l'ouverture de
soute de train à l'aide des vis 5/8"Phillips de tête de #10 X (q) comme montré dans l'étape 11 de cette instruction. Serrez
jusqu'а а l'aide douillettement d'un tournevis principal Phillips. Forez maintenant un trou de 1/8"par le fond du mudflap et
du panneau courant de fx comme montré ci-dessous. Fixez le mudlfap au fond du panneau courant de fx à l'aide des vis
5/8"Phillips de tête de #10 X (q) comme montré dans l'étape 11 de cette instruction.
Drill through mudflap and wheel
well opening.
Drill through bottom
of mudflap and
bottom of running board.
Drill with a
1/8" Drillbit
Wheel Well
Opening
Mudflap
Drill with a
1/8" Drillbit
Wheel Well
Opening
Drill with a
1/8" Drillbit
Drill with a
1/8" Drillbit
Drill with a
1/8" drillbit