Dee Zee DZE39922 - Manuel (Page 4)

1
Place bulb-seal gasket (B) onto the backlip of elite running board (A) and trim the bulb-seal gasket (B) so that it is flush
with the ends of elite running board (A) as shown below.
Coloque junta de culata de bombilla-sello (B) en el backlip del élite que corre la tabla (UN) y
recorta la junta de culata del bombilla-sello (B) para que sea al mismo nivel que los
fines del élite que corre la tabla (UN) como mostrado abajo.
B
A
3/16” Drill Bit
To o l s Re q u i r e d :
Outils Nécessaires:
Phillips Head
Screwdriver
Tin-snips
Tape Measure
Ratchet / Wrench
Sizes: 3/8“
7/16“
9/16"
13mm
Drill