STEINEL MF1-UL - Manuel (Page 4)

6 7
www.steinel.net (800) 852-4343 www.steinel.net (800) 852-4343 M-14307-1
Troubleshooting
Warranty
STEINEL America warrants its products
against defects in material or workmanship
for a period of fi ve years. STEINEL will
replace or repair the item provided that it
has not been altered or subjected to abuse,
accident, improper installation or improper
use. There are no obligations or liabilities on the part of STEINEL for consequential
damages arising out of or in connection with
the use or performance of this product or
other indirect damages with respect to loss
of property, revenue, or profi t, or cost of
removal, installation or reinstallation.
• Are the products you wish to connect set to the same group address?
• Is the receiver device too far away from the transmitting device, resulting in too weak of a
signal at the receiver? (See Transmission Range on page 3.)
• Can the radio signal leave the transmitter and reach the receiver or is it inhibited by
interference (metal enclosure etc)?
• Is there any possible interference from other transmitters operating on the same frequency?
• Are any other transmitters operating outside the system which, although working on a
different frequency, are doing so at very high transmission power (ham radio etc.)?
FCC ID - W8J7060
IC - 8529A-7060
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
conditions:
(1) this device may not cause harmful
interference
(2) this device must accept any interference
received including interference that may
cause undesired operation
(3) Changes or modifi cations not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment
Usages prévus
• A utiliser avec les dispositifs de
commande de l'éclairage sans fi l pour
commande groupée STEINEL
Dans ce paquet
• Module de commande sans fi l MF1-UL
• Consignes d'installation
Contenu du paquet
Aperçu de l'installation
ATTENTION
• Couper le courant au niveau du coupe-circuit avant installation
• Le module doit être installé et utilisé conformément aux codes et règlements
électriques appropriés
• Une installation par un électricien qualifi é est recommandée
• Insérer le module seulement lorsque le courant est COUPÉ
Adresse commutateur DIP
Connexion au dispositif de
commande sans fi l
1
2
1
2