STEINEL NM 5000-2-24 - Manuel (Page 4)

www.steinel.net (800) 852-4343 www.steinel.net (800) 852-4343
Installation
Ceiling mount installation with
threaded nipple
• Run low voltage wires from the
sensor through the provided
threaded nipple and snap
threaded nipple in back of
sensor
• Cut 7/8” hole in ceiling tile
• Place threaded nipple through
the hole in ceiling tile, add
washer and secure with locknut
• Wire sensor to STEINEL power
pack
Wall mount installation
• Remove decorative cover
• Remove screws securing the
front and back housings
• Separate the top housing from
the back housing
• Fasten the back housing to the
wall with screws through pre-
punched holes
• Connect low voltage wiring to
STEINEL power pack
• Reattach the front housing to
the back housing and secure
with screws
• Snap the decorative cover back
in place
6
Operation
7
This photoelectric lighting
controller measures ambient
brightness and automatically
switches the light ON at dusk and
automatically OFF as programmed
with the various switching options.