GE ZDIS150ZSS - Manuel (Page 10)

Installation Instructions
REVERSE THE DOOR SWING
IMPORTANT:
Disconnect power to the ice maker.
Tools Required:
‡µZUHQFK 66PRGHOV
‡7RU[VFUHZGULYHUVL]H
‡3KLOOLSVVFUHZGULYHU
Parts Identification: (For Reference Only)
Torx Door Catch
Screw
Hex Head Door
Skin Screw
Torx Hinge
Screw
Endcap Screw
Hinge Pin Phillips Head
Handle Screw
10
STEP 1 - REMOVE DOOR
For Black Model:
Remove the handle screws and lift off handle.
For Stainless Steel Model:
‡5HPRYHWZRKH[VFUHZVHDFKIURPWKHERWWRPRI
the stainless steel door skin.
‡3XOORXWRQWKHERWWRPSRUWLRQRIWKHGRRUVNLQDQG
lift up to remove.
STEP 2 - DOOR STOP AND END-CAP REVERSAL
1. Remove the hinge pin from the top hinge.
2. Remove the door from the hinges and replace the
top hinge pin.
3. Remove the screw and door stop at upper left
corner. Remove the screw and end cap at lower
right corner. Place the door stop at lower right
corner and tighten screw. Place the end cap at
upper left corner and tighten screw.
4. Remove the screw and door stop at lower left
corner. Remove screw and end cap from upper
right corner. Place the door stop at upper right
corner and tighten screw. Place the end cap at
lower left corner and tighten screw.
5. Set the door aside.
REVERSE THE DOOR SWING (cont.)
Screws
Handle
Hex screws
Stainless steel
door skin
Hinge pin