Electrolux EC1105AOW1 - Manuel (Page 10)

Problem Possible cause Solution
The lid is difficult to open. The lid gaskets are dirty or
sticky.
Clean the lid gaskets.
The compressor operates
continually.
Temperature is set incor-
rectly.
Refer to "Operation" chap-
ter.
Large quantities of food to
be frozen were put in at the
same time.
Wait some hours and then
check the temperature
again.
The room temperature is
too high.
Refer to climate class chart
on the rating plate.
Food placed in the appli-
ance was too warm.
Allow food to cool to room
temperature before storing.
The lid has been opened
too frequently.
Do not leave the lid open
longer than necessary.
The lid is not closed proper-
ly.
Check if the lid closes well
and the gaskets are un-
damaged and clean.
There is too much frost and
ice.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Refer to "Closing the door".
The water drainage plug is
not correctly positioned.
Position the water drainage
plug in the correct way.
Products are not wrapped
properly.
Wrap the products better.
Temperature is set incor-
rectly.
Refer to "Operation" chap-
ter.
The lid is not shut properly
or do not close tightly.
Check if the lid closes well
and the gaskets are un-
damaged and clean.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The products' temperature
is too high.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Many products are stored
at the same time.
Store less products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
www.electrolux.com 10