Bosch SGV63E03UC - Manuel (Page 14)

12
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the factory setting (P:01):
1
Open the door and press the [On/Off] button.
2
Hold down the “A” button and press [Start] until the display indicates “H:00”.
3
Release both buttons.
4
Press the “A” button until the display indicates “P:01”.
5
Press the “C” button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
6
Press [Start] to save the setting and close the door.
InfoLight
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the
LED is not visible.
To change the setting:
1
Open the door and press the [On/Off] button.
2
Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3
Release both buttons.
4
Press the “A” button until the display shows “1:01”.
5
Press the “C” button to switch between “1:01” = ON and “1:00” = OFF
6
Press [Start] to save and close the door.