ShelterLogic 26773 18 x 20 Super Max Canopy - Manuel (Page 6)

05-26773-0F Page 6
9. ANCHOR YOUR CANOPY
7. SECURE CANOPY COVER
10431
At the 4 middle legs, align the hole at the
top of the assembled leg with the hole at
the bottom of each 4-way connector.
Insert a short pin (10051) through this hole
to secure leg.
Working from the inside, slide the bungee
fasteners (10066) through the grommets.
6. SECURE THE MIDDlE lEGS
TO ROOF FRAME
There are four holes on each base foot that the anchor can go into.
Select a hole in each base foot. Insert each anchor into the ground
until the round head is touching the base foot.
Insert one anchor into all eight base feet.
This is a temporary spike anchor. Not intended for permanent use.
8. TIGHTEN THE COVER WITH
TWIST TITE
™
A. Wrap the cord with plastic ball and "S" hook at the
corners of the cover around the corner leg poles.
Insert "S" hook into the hole of the corner leg poles.
Twist each leg pole until the cover becomes tight.
Twist the leg poles equally to ensure the cover stays
aligned during tightening.
B. Secure the leg poles with the Twist-Tite™ Set.
(10056) Wrap the bungee around the side frame
connection (10045) and insert "S" hook into the leg
pole hole that lines up with the corner side frame
connector hole.
Twist-Tite™ Secure Leg Pole
802109
10159
10045
10056
10047
10051
10051
10047
Twist-Tite ™ Tighten Cover
802109
10159
10045
BUNgEE-BALL
AND CORD
HIDDEN UNDER
vALANCE
INSIDE vIEW
OF COvER
OUTSIDE vIEW
OF COvER