ShelterLogic 27772 30 x 30 UltraMax Peak Canopy - Manuel (Page 6)

05-27772-OC Page 6
step 5
step 6
Depending on the model you have purchased, your
base feet will either fit onto the outside of the leg
poles, or slide inside the leg poles. After installing
Base Feet Plates onto bottom of Support leg Poles,
be sure to line up the predrilled hole in the leg with the
predrilled hole in the base foot. Insert 5/16" x 3" bolts
all the way through leg and foot to other side, secure
with nuts.
Note: Don't insert the bolt to the corner legs at
this step.
Fig. 5A
Fig. 6A
Fig. 6B
Fig. 6
Fig. 5B
Tie a loop into the end of the
rope. Feed the loop over the
top of the rafter pole and feed
the other end of the rope through
the loop and run the rope down
the leg at least 12" and wrap
the rope around the leg and
feed the loose end over the
rope (Fig.6A).
Take the loose end of the robe
and secure it to the auger an-
chor already secured in the ground
(Fig.6B).Repeat these steps for the
remaining legs on the canopy.
rope