Air King B500 - Manuel (Page 3)

5. Plug both the 3 wire and 4 wire quick connect cords from the
blower into the appropriate receptacles located on the inside front
of the hood canopy. These cords will only fit into the receptacles
one way (Figure 3).
6. Reinstall the rear bottom plate by fitting the back edge of the plate
into the channel located on the back of the hood and reinstalling
the two nuts and washers removed in Step 1 (Figure 5).
SECTION 4
Finishing the Installation
1. Install the included fuse into the electrical panel by turning the
fuse cap counter clockwise and pulling out. Insert the included
1/4” x 1-1/4” time delay fuse in the holder and reinstall into the
panel (Figure 6).
www.airkinglimited.com 672016 Rev. C 4-10 3 of 8
NOTE: If you need to replace the fuse, replace with a 1/4" x 1-1/4"
Bussman MDA-3 or equivalent 3 amp, 250V ceramic, time delay fuse only.
2. Refer to the hood instruction manual to complete the installation,
for maintenance, and before restoring power.
3. The blower is covered under the range hood’s warranty.
Cap
Figure 6
Fuse
Figure 5
Nut
Washer
Bottom Plate