Gotham HID UP_DOWN CYLINDERS CHU 8_10 - Manuel (Page 3)

CJ5201021 Rev. B
2/2014 3 of 4
©2010 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
HID UP/DOWN CYLINDERS
CHU 8”/10”
Upon receipt, thoroughly inspect for any
freight damage which should be brought to
the attention of the delivery carrier. Compare
the catalog description listed on the packing
slip with the label on the carton to ensure you
have received the correct merchandise.
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
This product must be installed by a person
familiar with the construction and operation of
the product and the hazards involved, in
accordance with the applicable installation
code.
1. Electric current can cause painful shock
or serious injury unless handled properly.
For your safety, always remember the
following:
• Turn off the supply power.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands, when
standing on a wet or damp surface, or in
water.
2. Specific safety information concerning
lamps:
• Match wattage of fixture and lamp exactly.
• Do not remove or insert lamp when power is
on.
• Do not scratch glass or subject lamp to
undue pressure as either may cause lamp
breakage.
• Protect operating lamp from sources of
moisture.
• If lamp is marked
it contains
mercury. Follow disposal laws. See:
www.lamprecycle.org.
Figure 4
MOUNTING CYLINDER:
1. Loosen set screw in bottom of wall cover plate and remove mounting plate as shown in Figure 1.
2. Securely install mounting plate to mounting surface using pattern and orientation as shown in Figure 2.
3. Hook cylinder body to bottom lip of mounting plate. Make all wire connections and place wire/connectors
between wall cover plate and mounting plate or into junction box as shown in Figure 3.
4. Attach cylinder by hooking wall cover plate over top section of mounting plate as shown in Figure 4.
5. Secure cylinder to mounting plate by tightening set screw in bottom of wall cover plate.
6. After mounting fixture to wall, place a bead of silicone based caulking compound along the top and on each
side of the wall cover plate as shown in Figure 5. DO NOT CAULK ALONG THE BOTTOM.
SERVICING:
For servicing ballasts
1. Turn power off.
2. Remove lamp and reflector.
3. Remove (qty. 2) acorn nuts securing wall mount arm to cylinder.
4. Lift cylinder body off arm to gain access to ballast assembly. Disconnect socket wires from ballast and set
cylinder body aside. Replace ballast by placing in exact channel the defective ballast was removed from as
shown in Figure 6.
Figure 3
6”
Mounting
plate
5-3/8”
Figure 2 Figure 1
Set screw
Wall cover plate
Mounting plate
Mounting
surface
Figure 6
Caulking
Compound
Figure 5
Channel
Clearance holes
for 3/8” anchors