Gotham DLVI - Manuel (Page 3)

INSTALLATION INSTRUCTIONS
DLVI
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
WARNING - Turn of all power prior to beginning
any installation or maintenance of this fixture.
SUITABLE FOR INDOOR INSTALLATION ONLY
@ 25°C AMBIENT.
“ONLY TO BE INSTALLED IN OVERHEAD
CEILING”
IP20
CJ5201011 Rev. B
2/2014 3 of 6
©2010 Acuity Brands Lighting, Inc.
All Rights Reserved.
1. Electric current can cause painful shock or
serious injury unless handled properly. For
you safety, always remember the following:
 Turn off the supply power.
 Ground the fixture to avoid potential
electrical shocks.
 Do not handle an energized fixture or
energize any fixture with wet hands, when
standing on a wet or damp surface, or in
water.
2. Specific safety information concerning
lamps:
 Match wattage of fixture and lamp exactly.
 Do not remove or insert lamp when power is
on.
 Do not scratch glass or subject lamp to
undue pressure as either may cause lamp
breakage.
 Protect operating lamp from sources of
moisture.
 If lamp is marked it contains
mercury. Follow disposal laws. See:
www.lamprecycle.org.
SAVE THESE INSTRUCTIONS
Upon receipt, thoroughly inspect for any freight
damage which should be brought to the attention of
the delivery carrier. Compare the catalog
description listed on the packing slip with the label
on the carton to ensure you have received the
correct merchandise.
Figure 1 Figure 2
Figure 3
Figure 5
PRIOR TO INSTALLATION
• Follow these instructions carefully to insure correct and safe operation. Keep this sheet for
future needs. Contact the supplier with any problems.
• The fixture can not be modified. Any modification will void the warranty and can make the
product dangerous.
• Gotham Lighting shall not be responsible for any product damages caused by mounting
procedures which are not in accordance with instructions.
• Product installation shall be performed in a workmanlike fashion.
Continued on back
The equipment must not, under any
circumstances, be covered with any
insulating material.
Figure 4
Min. 0.75 mm 2 Supply Conductors
After connecting to terminal block, replace
transformer cover.