Gotham Ecos 4 & 6 Square Housing - Manuel (Page 3)

SAVE THESE INSTRUCTIONS
CJ520362 Rev. B
11/2013
3 of 8
FEED WIRE CONNECTION TO FIXTURE JUNCTION BOX (See Figure
6)
Junction box is approved for through wiring with eight No. 12 AWG conductors (4in/4out)
rated for a minimum of 90°C.
1. Remove junction box cover by releasing spring clip and allowing cover to hinge open.
2. Select knockout, remove, and install appropriate connector.
3. Install feed wire in accordance with national and/or local electrical codes.
4. Complete wiring.
5. Reinstall junction box cover.
Figure 6
ACCESS TO DRIVER AND THERMAL PROTECTOR
WARNING! Let fixture cool to touch before proceeding.
Touching while hot may cause injury!
1. Grip trim flange and pull down to remove from housing.
(See Figure 7)
2. Disengage dome retention clips (4) with flat head screwdriver.
(See Figure 8)
3. Reach inside dome placing fingers on top of heat sink and
thumb on bottom, push up. (See Figure 9)
4. Place dome assembly to the side allowing access to junction
box.
5. Reinstall dome assembly to mounting frame by aligning
retention clips with slots in mounting frame. Assure clips are
securely fastened to frame.
6. Reinstall trim.
REPLACING DOME ASSEMBLY
1. Grip trim flange and pull down to remove from housing.
(See Figure 7)
2. Disengage dome assembly retention clips (4) with flat head screwdriver.
(See Figure 8)
3. Reach inside dome placing fingers on top of heat sink and thumb on
bottom, push up. (See Figure 9)
4. Pull dome assembly through aperture. (See Figure 10)
5. Remove junction box from dome assembly with ¼” nut driver.
(See Figure 11)
6. Unplug connections between dome assembly and driver.
7. Connect new dome assembly.
8. Reinstall dome assembly to mounting frame by inserting it through
aperture and aligning retention clips with slots in mounting frame. Assure
clips are securely fastened to frame.
9. Reinstall trim.
!
Figure 7 Figure 8 Figure 9
Figure 10 Figure 11 Figure 12
Speed Nut