Gotham EVO SQ TRIM - Manuel (Page 2)

CJ520182 Rev. C
11/2013 2 of 4
©2010, 2012 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
Upon receipt, thoroughly inspect for any
freight damage which should be brought
to the attention of the delivery carrier.
Compare the catalog description listed on
the packing slip with the label on the
carton to ensure you have received the
correct merchandise.
INSTALLATION INSTRUCTIONS
EVO SQ TRIM
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
Warning: Risk of fire. Do not install
insulation within 3 inches of fixture
sides or wiring compartment, nor above
fixture in such a manner as to entrap
heat.
Electric current can cause painful
shock or serious injury unless handled
properly. For your safety, always
remember the following:
• Turn off the supply power.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp surface,
or in water
New Installation for EVO SQ Trim
1. Cut ceiling opening slightly larger than the outside diameter on mounting frame. For flangeless installation,
cut ceiling opening slightly larger than the outside of the vertical wall of the injection molded mudring.
Ceiling Cutout: 4” EVO SQ: 5-1/4”, 6” EVO SQ: 6-3/4”.
2. Pull light engine assembly included with mounting frame through ceiling opening as shown in Figure 1.
3. Attach light engine assembly to top of reflector by aligning and engaging the three (3) trim retention notches
(see Figure 2) on the reflector with the three (3) screws on the light engine (see Figure 3). Note label
instructions on trim (Figure 5). Drive in the screws using a Philips head screwdriver.
4. Push reflector/light engine assembly into ceiling opening aligning the torsion springs with the trim retention
brackets on the mounting frame (see Figure 4). Push until reflector flange is flush with the ceiling.
5. To remove the reflector: pull reflector downward squeezing the torsion springs until completely removed
from mounting frame. Using a Philips head screwdriver, loosen the trim retention screws on the light engine,
disengage the reflector by twisting to open position with the trim retention notches.
Figure 1
Figure 2
Figure 3
Figure 4
Retention Notches
Retention Screws
Torsion Springs
Retention Bracket
Label on trim shows the
correct installation position
Flex conduit connector
Figure 5