Gotham ICO-SQ Trim - Manuel (Page 2)

CJ5200913 Rev. C
11/2013 2 of 4
©2010, 2012 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
Upon receipt, thoroughly inspect for any
freight damage which should be brought
to the attention of the delivery carrier.
Compare the catalog description listed on
the packing slip with the label on the
carton to ensure you have received the
correct merchandise.
INSTALLATION INSTRUCTIONS
ICO & ICO-SQ Trim
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
Warning: Risk of fire. Do not install
insulation within 3 inches of fixture
sides or wiring compartment, nor above
fixture in such a manner as to entrap
heat.
Electric current can cause painful
shock or serious injury unless handled
properly. For your safety, always
remember the following:
• Turn off the supply power.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp surface,
or in water
New Installation for IncitoTrim
1. To install reflector, simply insert reflector into housing. Mounting clips will secure trim to housing.
Reflector flange should be flush with ceiling once installed. Note: Square trim mounts in same
fashion.
Figure 1
Housing
Reflector
Mounting Clip
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any
interference
received, including
interference that may cause undesired
operation.