Gotham EVO LW Mounting Frame - Manuel (Page 3)

CJ5201006 Rev.H
02/2014 3 of 6
©2010, 2012 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
Non-Flexible Wiring Method
3. If non-flexible wiring method is used, follow procedure for flexible wiring method. Then lower mounting frame equal to the thickness of the finished ceiling or
slightly above as shown in Figure 4.
4. If additional security is required, a No. 8 sheet metal screw, wire tie or wire (not supplied) may be used to tie the latch arm to the mounting frame as shown in
Figure 1.
5. Remove knockouts on junction box to feed power supply to fixture as shown in Figure 5. Supply wire must meet applicable electrical codes and be rated for a
minimum for 75°C. Junction box is thru-wire rated for 8-No. 12 AWG conductors (4in-4out). Driver is standard with 0-10V dimming capability with wires
provided by others.
6. Complete necessary splices. Snap the door/driver assembly onto the junction box as shown in Figure 5.