Napoleon Grills CSS610RSB - Manuel (Page 6)

6
Open lid.
Main Burner Lighting
Push in on any main burner
knob and turn to “HI”. A
click should be heard from
the valve, sending a spark
to light the pilot flame.
If ignition is not immediate,
turn burner control off.
Wait 5 minutes.
Ensuring all burner controls
are in the off position,
slowly turn on the gas
supply valve.
RIGHT
BURNER
LEFT
BURNER
REAR BURNER IGNITER
The propane cylinder is equipped with an excess flow device. Unless all burners are turned
off prior to turning the cylinder on, only small flames and low heat will be achievable.
Side Burner Lighting Rear Burner Lighting
Remove warming rack.
(the excess heat will
cause the rack to warp.)
Push the knob and hold
for approximately 5
seconds before rotating.
This allows gas to reach
the rear burner. Rotate
the knob to “HI” and press
the igniter button.
Open burner cover.
If ignition is not immediate,
turn burner control off.
Wait 5 minutes.
Push the side burner
control knob and turn to
“HI” position. A click
should be heard form the
valve, sending a spark to
light the pilot flame.
If ignition is not immediate,
turn burner control off.
Wait 5 minutes.
REAR
BURNER
CENTRE
BURNER
LIGHTING INSTRUCTIONS
If the burner will not light
after several attempts, it
can be lit by inserting a lit
extended match or lighter
through the cooking grids
to the burner. Push the
knob in and turn to “HI”.
If the burner will not light
after several attempts, it
can be lit by holding a lit
extended match or lighter
against the burner. Push
the knob in and turn to “HI”.
If the burner will not light
after several attempts, it
can be lit by holding a lit
extended match or lighter
against the burner. Push
the knob in and turn to “HI”.
SIDE
BURNER