Initial settings, Adjusting initial settings, Setting the time – Pioneer DEH-P6400 Manuel d'utilisation
Page 32: Switching the warning tone
07
Section
Initial Settings
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1
FUNCTION
display
Shows the function status.
1 Press
SOURCE
and hold until the unit turns
off.
2 Press
FUNCTION
and hold until time
appears in the display.
3 Press
FUNCTION
to select one of the initial
settings.
Press
FUNCTION
repeatedly to switch between
the following settings:
CLOCK
—
WARN
—
AUX
—
DIM
—
BRIGHT
—
SW
—
TEL
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
BAND/ESC
.
• You can also cancel initial settings by holding
down
FUNCTION
until the unit turns off.
Setting the time
This is used to set the time on the unit’s clock
display.
1 Press
FUNCTION
to select the
CLOCK
.
Press
FUNCTION
until the time appears in the
display.
2 Select the portion of the time display you
wish to set with
2/3.
Pressing
2/3 will select a portion of the clock
display:
HOUR
—
MINUTE
As you select portions of the clock display the
portion selected will blink.
3 Select the correct time with
5/∞.
Pressing
5 will increase the selected hour or
minute. Pressing
∞ will decrease the selected
hour or minute.
Switching the warning tone
If the front panel is not detached from the head
unit within five seconds of turning off the igni-
tion, a warning tone will sound. You can turn off
this warning tone.
1 Press
FUNCTION
to select
WARN
.
Press
FUNCTION
repeatedly until
Warning
appears in the display.
2 Select
WARN
on or off with
5/∞.
Pressing
5/∞ will switch
Warning
between on
and off and that status will be displayed (e.g.,
Warning :ON
).
1
En
32