Petsafe In-Ground Fence Kit - Manuel (Page 4)

4 www.petsafe.net
The Receiver Indicator Light acts as a low battery indicator, fl ashing every 4 to 5 seconds when
battery replacement is required.
Indicator
Light Response Mode Receiver Collar Function Temperament of Pet
1 Flash 1 Low Static Correction Timid or Average
2 Flashes 2 Medium Static Correction Timid or Average
3 Flashes 3 High Static Correction High Energy
4 Flashes 4 Tone Only
Flashes once every 4
to 5 seconds Low
Battery
Note: Begin training with Mode 1 and only increase if your pet does not respond to the Static Correction.
____________________________________________________
Fit the Receiver Collar
Important: The proper fit and placement of your Receiver
Collar is important for effective operation. The Contact
Points must have direct contact with your pet’s skin on the
underside of his neck.
To ensure a proper fit, please follow these steps:
1. Make sure that the battery is not installed in the Receiver
Collar.
2. Have your pet standing comfortably (2A).
3. Centre the Contact Points underneath your pet’s neck,
touching the skin (2B).
Note: It is sometimes necessary to trim the hair around the
Contact Points to make sure that contact is consistent.
YES
NO
2A
2B
4. The PetSafe QuickFit™ Collar is designed so you can
quickly attach and remove the Receiver Collar from
your pet while maintaining the desired fit.
a. With the Snap Buckle fastened (2C), thread the
collar through the Metal Buckle (2D).
b. Slide the excess collar through the “C” Loop on
top of the Snap Buckle (2E). This will hold the
excess collar in place.
c. Once the collar fit is determined, use the Snap
Buckle to remove and replace the collar.
5. The Receiver Collar should fit snugly, yet loose
enough to allow one finger to fit between a Contact
Snap Buckle
2C
“C” Loop
Metal Buckle
2D
2E 2F