Pioneer DEH-P8400MP - Manuel (Page 44)

Initial Settings
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1 FUNCTION display
Shows the function status.
1 Press SOURCE and hold until the unit turns
off.
2 Press OPEN to open the front panel.
3 Press FUNCTION and hold until CLOCK
appears in the display.
4 Press FUNCTION to select one of the initial
settings.
Press
FUNCTION repeatedly to switch between
the following settings:
CLOCK — WARN — D OPEN — AUX — DIM —
BRIGHT — SW — TEL — DISP
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
BAND .
• You can also cancel initial settings by holding
down
FUNCTION until the unit turns off.
Setting the time
This is used to set the time on the unit’s clock
display.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select CLOCK .
Press FUNCTION until the time appears in the
display.
3 Select the portion of the time display you
wish to set with
2/3.
Pressing 2/3 will select a portion of the clock
display:
HOUR — MINUTE
As you select portions of the clock display the
portion selected will blink.
4 Select the correct time with
5/∞.
Pressing
5 will increase the selected hour or
minute. Pressing
∞ will decrease the selected
hour or minute.
1
En 44
08
Section