Lenovo 1044 - Manuel (Page 84)

Table 25. Items under the Boot menu
Item Sub-item Option Description
Quick Boot [Disabled] / Enabled Enable or disable the quick
boot feature.
Quiet Boot [Enabled] / Disabled Enable or disable the
feature to show OEM Logo
during the POST.
AddOn ROM / Display
Mode [Force BIOS] / Keep Current Set the AddOn ROM
Display Mode.
Boot Settings Configuration
Bootup Num-Lock [Off] / On Set the Num-Lock LED
state.
1st Boot Device Boot device names Boot Device Priority
2nd Boot Device Boot device names
Set the startup device
sequence (support at most
five startup devices).
Hard Disk Drives 1st Drive / 2nd Drive... Based on the installed hard
disk drives.
CD/DVD Drives 1st Drive... Based on the installed
optical drives.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 26. Items under the Security menu
Item Description
Change Supervisor Password Set or change the supervisor password. The password
can be any combination of up to 6 (1 to 6) alphabetic and
numeric characters.
Change User Password Set or change the user password. The password can
be any combination of up to 6 (1 to 6) alphabetic and
numeric characters.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 27. Items under the Chipset menu
Item Sub-item Option Description
QPI Frequency [Auto] / 4.800GT / 5.866GT
/ 6.400GT Standard transferring rate
of the QPI bus.
QPI L0s and L1 Disabled / [Enabled] Enable or disable the QPI
L0s and L1.
Memory Frequency [Auto] / Force DDR-800 /
Force DDR-1066 / Force
DDR-1333 Set the frequency of the
memory module. Make
sure that the mandatory
memory frequency setting
is less than the maximum
frequency that the memory
module can support.
CPU Bridge Configuration
Memory Mode [Independent] / Channel
Mirroring / Lockstep Set the memory channel
mode to improve reliability
or efficiency.
74 ThinkServer Installation and User Guide