Sanyo HT28745 - Manuel (Page 11)

11
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
USING THE REMOTE CONTROL
REMOTE CONTROL KEYS
➀
Power Key—Press to turn DTV on or off.
➁
I nput Key—Press to change the input signal source
as follows: Analog RF
➡ Digital RF ➡ Video1 ➡ Video2
➡Compo2 ➡ Compo3 ➡ Analog RF.
➂
Number Key—Two keys must be pressed to select a
direct channel.
Example: Press 0 then 6 to select
channel 6. For Analog Cable channels above 100,
press and hold the 1 key until C1– – appears.
➃
Info Key—Press to display the Digital and Analog Full
Banner information (press again to remove the
display):
Digital Full Banner display—Contains a two-part
Channel Number (Major and Minor). If available the
following is also included–Station ID, Program Title,
Date/Time (if set), Antenna Signal Strength, Video Res-
olution, V-Chip Program Rating, and Audio Reception.
Point towards
DTV
➠
➀
➁
1
4 5 6
7 8
0
9
2 3
POWER
INPUT
INFO
RECALL
MENU
CAPTION EXIT
ENTER
TUNER MUTE
SLEEP
➂
➃
➄
➅
➆
PRECAUTIONS
To ensure safe operation, please observe the following precautions:
Replace both batteries at the same time. Do not use a new battery with
a used battery. Risk of explosion, if battery is replaced by an incorrect
type.
Do not expose the Remote Control Unit to moisture, or heat.
Digital 50-1 D i g i t a l 5 0 - 1 WREG-DT 9:16pm, Mon Mar 07
1920*1080(60i)
Dining Out
Weak Strong
English
G
Virtual Channel
Major Minor
Station ID Time/Date
Program
Title
Audio
Reception
V-Chip
Program
Rating
Video
Resolution
Signal
Strength
Analog Full Banner display—Contains Channel
Number (analog antenna/cable), Date / Time (if set),
Station ID (if available), Program Title (if available),
V-Chip Program Rating, and Audio Reception.
Analog 12 Analog 12 PBS 9:16pm, Mon Mar 07
Dining Out
Stereo
G
Station ID Current Time/Date
Program Title Audio
Reception
V-Chip Program
Rating
Channel No.
➄
Recall Key—Select the first channel you want to
watch; then select another channel using the
NUMBER keys. Press RECALL to easily switch
between the channels.
NOTE: The RECALL key cannot toggle between a
Digital channel and an Analog channel. See TUNER
(#7) key description.
➅
Menu key—Press this key to display the on-screen
menu.
➆
Tuner Key—Use this key to toggle from one tuning
system to another, digital channels, and analog
channels.
NOTE: The TUNER key is inactive when an external
input is selected (Video 1, Video 2, Compo 2, or
Compo 3).
➇
Cursor ▲ (up) ▼ (down) keys—Press these keys to
move the cursor up and down within the menu.
Cursor
(left) (right) keys—Press these keys to
move the cursor left and right within the menu.
(Continued on page 12.)
➇