SVAT Electronics GX5150 - Manuel (Page 6)

w w w . s v a t . c o m
INSTALLING THE MONITOR (RECEIVER)
1. Unpack the monitor.
2. Connect the supplied 6V power adapter to the back
of the monitor (adapter marked “FOR MONITOR”.
*WARNING: USE OF ANY OTHER ADAPTOR MAY CAUSE DAMAGE
TO THE SYSTEM*NOTE: Monitor is also battery operable using
4 AA type batteries (not included)
3. Turn on the monitor by pressing the power button.
4. The monitor can be connected directly to any
TV/VCR (optional) using the supplied cable
connect the 3.5” jack to the rear of the GX5150
monitor. Next connect the yellow RCA cable to
your VIDEO IN and the white RCA cable to the
AUDIO IN jack on your TV or VCR.
Viewing on TV: Tune your TV to a VIDEO/AUX
channel (refer to your TV user manual)
Recording to a VCR: Tune your VCR to a Video/AUX channel, tune your TV
to the proper input channel or Channel 3 or 4. You are now ready to record.
5. The monitor is wall or desk mountable. For wall installation, install the
bracket onto the wall and mount the monitor on to the bracket.
6. The monitor (receiver) installation is now complete!
MULTI -CAMERA OPERATION
The GX5150 system is designed to work with up to 3 cameras (GX515).
Additional cameras are sold seperatley.
1. Designate a selected channel for each camera. Simply adjust the channel
switch (located at the bottom of the camera head) to the desired position
1,2 or 3. Refer to step 5 in the camera installation section of this manual.
2. Adjust the dip switches found on the back of the monitor to reflect the
channels in use.
Back of Monitor and Adapter
shown to the right.
Camera 1
in use
Cameras
1&2 in use
All Cameras
in use