Troubleshooting – John Deere TY25864 Manuel d'utilisation
Page 39

Troubleshooting
OUOD006,000001E
–19–17JUN04–1/1
Troubleshooting Battery Charger
Symptom
Problem
Solution
Battery connected and charger
Charger in tester mode, not charger
Press CHARGE RATE button to
on, but battery not charging.
mode.
activate charger, and select a charge
rate.
Indicator lights illuminate in an
Charger in a special diagnostic
Make sure nothing is touching the
erratic manner not explained in
mode.
control panel, then unplug the unit
“Controls and Operation”
and plug it in again.
section.
Charger defective.
Return unit to place of purchase for
replacement.
The CHECK (red) light flashes
Incorrect battery type selected.
Reset charger by briefly unplugging
before battery is completely
it or briefly disconnecting the battery
charged.
clamp to ground, and select proper
charge rate and battery type.
Battery did not reach full charge in
Reset charger by briefly unplugging
24 hours.
it or briefly disconnecting the battery
clamp to ground, and select proper
charge rate and battery type.
Engine crank time is less than
Starter motor drawing more than 100
Charge battery at 40A rate for 10 to
specified.
amps.
15 minutes, then crank the engine.
The CHARGED (green) light
Battery voltage high enough for
Turn headlights on for a few minutes
illuminates a few minutes after
battery to appear to be fully charged.
to reduce battery voltage and try
connecting charger to battery.
charging again.
Incorrect battery type selected.
Reset charger by briefly unplugging
it or briefly disconnecting the battery
clamp to ground, and select proper
charge rate and battery type.
15-1
091604
PN=39