MoistAir MA1201 - Manuel (Page 7)

Step 4. Operating the Controls
Where you set your desired humidity
levels depends on your personal comfort
level, outside temperature and inside
temperature. A starting set point of 30% -
40% ROOM humidity is recommended
but there may be conditions that require
a different setting.
7
IMPORTANT: Water damage may
result if condensation starts to form
on windows or walls. Humidity SET
point should be lowered until
condensation no longer forms. We
recommend room humidity levels do
not exceed 50%.
-10° F
2° F
10° F
20° F
20%
25%
30%
35%
When Outdoor Recommended Indoor
Temperature is: Relative Humidity (RH) is:
* and above
* *
To Operate the Controls
Digital Display
Press the power button once to
display the digital readout*. Initially there
is a slight delay while the electronics
calibrate.
Two bars (- -) flash during this time.
Once calibration is complete a ROOM
humidity reading between 20% - 95% will
be displayed. A flashing 20 display
indicates that the room humidity is less
than 20%.
NOTE: The default settings at initial
startup are ULTRA QUIET fan speed and
65% SET humidity. After desired settings
are selected by the user, they remain as
long as the unit remains plugged in and
there is no power interruption. If the unit
is unplugged the original default settings
are employed.
* Humidifier fan should operate at initial start
up. If it does not, refer to, “Fan not operating
(digital display is illuminated)” in the “Trouble
Shooting” section on page 13 of this manual.
-24° C
-18° C
-12° C
-6° C