Faber CRISTAL HC - Manuel (Page 7)

Version 09/12 - Page 7
USE AND CARE INFORMATION
Rangehood Control Panel
All controls are located on the right side of the rangehood.
Light On/Off Switch
TheOn/Off switch for the fluorescent light is located behind the
front trim. Moving the switch to the 1 Position turns the light
On. Moving the switch to the 0 position turns the light off.
Blower Speed Switch
B in FIGURE 10 shows the speed control switch for the
blower. Moving the switch to the 1 Position turns the blower
on LOW. Moving the switch to the 2 Position turns the blower
on MEDIUM. Moving the switch to the 3 Position turns the
blower on HIGH. Moving the switch to the 0 Position turns
the blower off.
Automatic Operation
As long as the blower and light switches are on, the blower
and light will automatically operate when the visor is opened
and shut off when the visor is closed.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from
the kitchen.
Cleaning
The metal grease filters should be cleaned frequently in hot
detergent solution or placed in the dishwasher. Clean exterior
surfaces with hot soapy water. Using abrasives and scouring
agents can scratch rangehood finishes and should not be
used to clean finished surfaces.
Replacing the Fluorescent Light
USE CAUTION AS THE BULB MAY BE HOT
To replace the fluorescent light, remove the diffuser clips from
both ends of the glass diffuser (L in FIGURE 10) by removing
the screws. Carefully slide the glass diffuser all the way to the
right. Lower the left end of the glass below the support flange,
then remove the glass by sliding it back to the left. Replace
the diffuser glass by reversing these directions.
FIGURE 10
L
FRONT TRIM OPTIONS
The Cristal HC comes with a white front strip installed. Optional
black and brushed aluminum strips are included in the box. To
change the front strip, remove the three phillips screws located
behind the strip (FIGURE 8). If necessary, the front strip can
be adjusted by loosening the three phillips screws and sliding
the strip up or down. Tighten screws when you have the strip
properly placed.
For a custom front strip, a local cabinet shop can make a strip
to match your cabinets. The front strip dimensions are given
in FIGURE 9.
FIGURE 8
1 15/32"
FIGURE 9
3/4" 29 7/8" or 35 7/8"
Visor
Front
Strip
Three Screws
B